The first step is setting the stones in the Pendant bases
I Place the stone in the Center of the stone setting and
with the help of the setting tool I bend the prongs towards the stone in order
to embed it
I bend it gently to make sure I don't damage the
stone or the plating
The next step is Connecting the Dragon fly pendant base and the Navette setting with loops to one Center piece
I connect one Navette setting on both sides of the Dragon fly Pendant by their side loops with 5mm jump rings
I cut the 3.7X3mm oval chain into two pieces of 16.5cm lon
I connect one chain to the right side loop of the Dragon fly center piece with a 5mm jump ring
I connect the other chain to the Left side loop of the Dragon fly center piece with a 5mm jump ring
Next, I cut 10cm piece of extension chain
I connect the extension chain to the left chain that I connected to the pendant in the
previous step with a 5mm jump ring
.jpg)
Last step, I connect the clasp to the right chain of the necklace with a 5mm jump ring
.jpg)
Hope you enjoyed the process! Cup Chain team
