.jpg)
The first step is setting the stones
I Place the stone in the Center of the stone setting and with the help of the setting tool I bend the prongs towards the stone in order
to embed it
I bend it gently to make sure i don't damage the stone or the plating
The next step is cutting the chains
I start with the 6mm round loops chain and cut it into 6 pieces
of 7.5cm each
I Cut the 3.8mm round loop chain to four pieces of 18cm
I continue with connecting the octagons and the oval stone settings to the 6mm round chain
In each end of the six pieces of the 6mm round loop chain I connect one 6mm jump ring
Next, I Connect a chain with jump ring in each side loop of the 13X18mm oval and the 13X18mm octagon stone settings
Next,you need to choose two pieces out of the three that you made in
the previous step,the third piece with stone that remain will be the stone in the middle of the bracelet
I chose the 13X18mm oval and 13X18mm horizontal Crystal
octagon
I Take two pieces of the 3.8mm round loop chains together with the chain with the oval setting and gather the three ends from each side with one 6mm jump ring
I repeat the same action with the chain with the horizontal octagon
setting
Next, i take the piece of chain with octagon setting that left
and connect a 6mm jump rings in each end of the chain
Next step I start connencting the all pieces to one bracelet
I take the 39ss Ends Connectors and connect the chains ends to the Ends connectors
First connect the group chains with the oval setting to the top loops of the connectors
Next I Connect the 6mm round chain with the octagon Setting to the middle loops of the connectors
Last I connect the group of chains with the horizontal octagon
setting to the bottom loops of the Ends Connectors
You can change the order and the number of chains
as you wish
Last Step is connecting the clasp to the bracelet
Connect a 5mm jump ring to the clasp and then connect the jump ring to the big side loop of one of the End Connectors
.jpg)
