The first step is setting the stones a in the End connectors and the Necklace parts
I Place the stone/embedding element in the Center of the stone setting and
with the help of the setting tool I bend the prongs towards the stone in order
to embed it
I bend it gently to make sure I don't damage the
stone or the plating
The next step is connecting the Necklace Parts to the two end connectors with a 6mm jump rings
I start with connecting the 9 39ss setting Necklace part to the the up loops
of the end connectors
Next I connect the 12mm Square Necklace part to the middle
loops of the end connectors
Last , I connect the 17 39ss settings to the bottom
loops of the end connectors
The Next step is Cutting the 5mm Gourmet Chain chain into 2 pieces of 10cm long
To "cut" the necklace you don't need to use a cutting tool,
you can open one link in the chain with a help of two plier tools
I connect the two chains to both sides of the center piece to loops of the settings with
a 5mm jump ring
I connect 10 cm of extansion chain to the big loop of the
The last step is connecting the 12mm clasp to the right chain of the necklace with
a 6mm jump ring
Enjoy Your new necklace! Cup Chain team
