We start with setting the stones. Place the stone in the setting as shown in the picture
There are four prongs around the setting
With the help of a plaier tool press the prongs gently towards the stone in order to lock the stone inside
Use the plaier without using force, So you make sure the stone and the plating doesn't get damaged
Next step is connecting the three 39ss special settings
together with 6mm jump rings
Thread the jump ring through the middle setting as shown in the picture
The three settings together will be the center piece of
the necklace
Next, I cut the round loops chain into two pieces of 18cm long
I connect the two chains to both sides of the center piece to loops of the settings with a 6mm jump ring
I cut 10cm piece of extension chain
I connect the extension chain to the left chain of the necklace with a 6mm jump ring
The last step is connecting the 12mm clasp to the right chain of the necklace with
Hope you enjoyed the process